Member of the Month

partyandBS
December, 2024

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

Help with me binding porfavor

profile picture
T-Brizzle
Posts: 4 - Karma: 18
I was testing out the backyuard set up we just built when my bindings started popping part way up. both started doing it at the same time somehow, but I can also put all my weight into a butter or nose stall or whatever without popping out. I'm assuming I prob bumped smth throwing my skis up just wanna know what. I thought maybe forward pressure but I don't rly know much. I attached the whole clip so u can see my steez.


https://youtu.be/1-tJGypRms4
Jan 8 2025 7:44PM
2 0
profile picture
ASSholebomber22
Posts: 6744 - Karma: 71,656
With the boot clicked in show a pic of the screw at the back and the din window
Jan 8 2025 7:47PM
0 0
profile picture
T-Brizzle
Posts: 4 - Karma: 18
ASSholebomber22With the boot clicked in show a pic of the screw at the back and the din window



Jan 8 2025 8:14PM
0 0
profile picture
snorman
Posts: 50 - Karma: 202
Forward pressure probably wrong go get that checked and you’re set
Jan 8 2025 8:20PM
1 1
profile picture
ASSholebomber22
Posts: 6744 - Karma: 71,656
T-Brizzle

Are you pressing hard on your toes and lifting your heels in the vid? Or just lifting your whole foot? Could be the fwd pressure slipped in which case the bindings may be broken but I think you're just seeing elasticity in the binding - they'll move a bit before the actually release when there's force on them
Jan 8 2025 8:26PM
0 0
profile picture
T-Brizzle
Posts: 4 - Karma: 18
ASSholebomber22Are you pressing hard on your toes and lifting your heels in the vid? Or just lifting your whole foot? Could be the fwd pressure slipped in which case the bindings may be broken but I think you're just seeing elasticity in the binding - they'll move a bit before the actually release when there's force on them


I'm not just lifting my foot I am pressing my toes but not very hard at all def shouldn't be coming up at least that much. When i was on the grass I put alot more pressure and they came out further but I was able to put all my weight on the tips (as in underfoot not touching the ground and not holding onto anything or hands on the ground) and I didn't pop fully out.
Jan 8 2025 8:34PM
1 0
profile picture
ASSholebomber22
Posts: 6744 - Karma: 71,656
T-BrizzleI'm not just lifting my foot I am pressing my toes but not very hard at all def shouldn't be coming up at least that much. When i was on the grass I put alot more pressure and they came out further but I was able to put all my weight on the tips (as in underfoot not touching the ground and not holding onto anything or hands on the ground) and I didn't pop fully out.


You're probably fine, your dins aren't too high and the binding is designed to use its travel before it releases. If they didn't move a good amount before releasing it would feel really harsh when you eject. If you're really concerned about it take it to a shop, they'll have a special torque wrench to see if your binding releases when it should or not
Jan 8 2025 8:55PM
0 0
profile picture
Non_State_Actor
Posts: 4909 - Karma: 17,504
T-Brizzle

Forward pressure looks good though it's a little hard to tell at this angle. Are your dins set to like 5.5?
Jan 8 2025 10:11PM
0 0
profile picture
PartyBullshiit
Posts: 4218 - Karma: 18,821
Non_State_ActorForward pressure looks good though it's a little hard to tell at this angle. Are your dins set to like 5.5?


Looks almost like. 6-7
Jan 8 2025 10:15PM
1 0
profile picture
T-Brizzle
Posts: 4 - Karma: 18
Dins are 7 but I don't weigh very much. again they don't release if i put all my weight on the tips and to be more specific they go way beyond what they did in the video with a lot less then all my weight, but once they reach that point they don't pop out even with all my weight.

I think imma get them checked out by a shop
Jan 8 2025 10:57PM
1 0
profile picture
ASSholebomber22
Posts: 6744 - Karma: 71,656
T-BrizzleDins are 7 but I don't weigh very much. again they don't release if i put all my weight on the tips and to be more specific they go way beyond what they did in the video with a lot less then all my weight, but once they reach that point they don't pop out even with all my weight.

I think imma get them checked out by a shop


That's a good call, my money's on they're fine tho. Keep us updated!
Jan 8 2025 11:03PM
0 0
profile picture
tdollo
Posts: 3810 - Karma: 18,920
what do your boot soles look like? Could have to do with excessive wear on the lugs. Have a look at your toe height as well, you can adjust it using a screwdriver in the front of the toe piece. The AFD (the silver thing on the toe piece on Attacks) should be fairly snug to the sole of your boot. Clip the boot in and slide a business card between your boot and the afd, then tighten it until theres some friction between the card when you pull it out.
Jan 10 2025 12:38AM
1 0
All times are Eastern (-5)