Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
Pivot forward pressure indicator
Posts: 2551
-
Karma: 10,008
So when I clip in my 320bsl boot, FP indicator is lined up. When I clip in my 325bsl boot, FP indicator does not change at all. Still lined up.
Is the indicator just a very rough guide or does it take a much larger change in BSL to move it?
Posts: 2405
-
Karma: 8,735
its kind of a rough guide. But if you have grit/sand/dirt/poop stuck in the slider binding it up, you'll have the wiggle the heel piece side to side to reset it. It could just not be moving from boot to boot because its stuck.
Posts: 4517
-
Karma: 20,774
Super rough estimate. Supposedly the 2.0 version is better. Haven’t had a chance to try them yet though.
Posts: 4570
-
Karma: 26,372
It’s an estimate/a starting point. The Look manual states that you have to check the white tab first, then grab the dildo and twist it around the heel of the boot to make sure it doesn’t move too little/too much. Using a Vermont calibrator after both of those things will give you a final confirmation. Sort of a pain to tech Pivots compared to others because of it 👎
Posts: 5024
-
Karma: 18,156
Vibes based forward pressure adjustments.
Posts: 1512
-
Karma: 2,697
Non_State_ActorVibes based forward pressure adjustments.
The beauty of pivots!
All times are Eastern (-4)
