Is bending brakes bad

the brakes will probably fit as is tbh

Voyage86the brakes will probably fit as is tbh

I followed this advice and the brakes never deploy. Respectfully, fuck this advice

Carefully use a torch and pliers to bend them slowly, OP. They should be okay but you also might have to shave some of the plastic parts off, too.

ReturnToMonkeyI followed this advice and the brakes never deploy. Respectfully, fuck this advice

Carefully use a torch and pliers to bend them slowly, OP. They should be okay but you also might have to shave some of the plastic parts off, too.

that’s interesting. i have 90 mm brakes on my 96s and i have zero complaints.

Voyage86that’s interesting. i have 90 mm brakes on my 96s and i have zero complaints.

Depends on the binding! Pivots will usually fit a bit wide because the plastic pits on the brake are low profile but so ething like an attack binding has much less lee way as the plastic is a bit bigger. I usually go + or - 5 from the set width but sometimes you can squeeze in a couple more mm