It looks like you are using an ad blocker. That's okay. Who doesn't? But without advertising revenue, we can't keep making this site awesome. Click the link below for instructions on disabling adblock.
Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
Cuff alignment part just decided to yeet itself somewhere... I've emailed Salomon for a spare part but you know sure as shit its going to take 30 days. Any ideas?
officechairBolt from Home Depot with smaller washers in the hole and and big one for the outside?
Or get a bolt and some acrylic, polycarbonate, or similar scrap (ask an employee). Cut a small insert then drill the hole offset. Do the same with a larger piece and file some grooves to fit the teeth.
Yaaa, would have to find a washer with similar grooves I think, else the cuff would just be super flexy on one side. Here is better pic of how its set up.
mikemGot some buddies that work at local shops around here, one of em said they might have a part so going to drive down to em to see.
Called salomon cs to ask and the lady hung up on me the second I asked if it was the same part as atomic so idk.
Try to contact the local Salomon rep, in my experience the reps are super helpful. The Cs for Salomon has done the same thing for a few warranties at my shop.
Yo, so I went to a shop where my friends work, they didn't have a spare part so we just washer and screwed it. It was pretty good, didint have an exact match washer but boot was def good to go.
On my way home i stopped by another shop because i knew they sold atomics. Guy checked it out, he said the atomic part is slightly bigger on the inner hole. He did tho end up having a spare salomon and slapped in on there.
