Member of the Month

hi_vis360
November, 2024

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

My Vishnus are on life support

profile picture
FranklinTheSkier
Posts: 138 - Karma: 380














I know I already made a thread about this but it’s getting exponentially worse. I contacted emmet and he generously sent me a new ski as warranty, but the problem is It was only sent one ski (most likely because I told him that only one of my skis was damaged at the time), but both my skis are destroyed at this point. I’m most likely going to just buy a new pair of Vishnus next season but in the mean time how do I preserve these and how can I prevent this from happening again in the future?

I counted 14 edge cracks across both skis
2 core shots, one of them being pretty big
edge peeling off at tip
multiple edge dents
top sheet damage is fine idrc

(All of this over the span of around 16 days skiing)
Mar 12 2023 7:43PM
8 34
profile picture
powpatrol
Posts: 1703 - Karma: 11,033
that’s not life support they’re just starting to get broken in
Mar 12 2023 7:52PM
64 3
profile picture
hi_vis360
Posts: 5104 - Karma: 51,867
Bro those core shots are nothing I have one that goes through the fiberglass
Mar 12 2023 8:36PM
18 0
profile picture
verynormalguy
Posts: 480 - Karma: 7,920
Little epoxy in the right places and they’re good to go, they’re not really on life support till the edges start falling out of the ski
Mar 12 2023 8:37PM
24 0
profile picture
thewayshego3s
Posts: 191 - Karma: 1,566
It’s all part of the process of hitting rails/jibbing. I think it’s pretty fun taking the skis into the garage and fixing them up. Little epoxy and p Tex goes a long ways. Best of luck, soldier
Mar 12 2023 9:30PM
20 0
profile picture
-Dan
Posts: 7146 - Karma: 52,235
you’ve just gotta change your idea of what broken is. Those joints you have work plenty fine and will for a while more with some maintenance. They are breaking. All skis do when you spend time hitting rails. They are not broken tho. Not yet.

you can get those core shots filled. You can get that peeling edge in the tip cut and bent in so it doesn’t keep ripping out. The edge cracks underfoot maybe would have been less intense with a more thorough detune, if you didn’t do that. They will not be an issue really until the metal starts falling out and water get in there. Even then you and rip em still until it’s fucked up water logged or your screws pull out from the rot.

wishing you best of luck!
Mar 12 2023 10:52PM
30 1
profile picture
Vish-shoe
Posts: 1949 - Karma: 14,507
with the power of West Systems Gflex Epoxy, those can be as good as new
Mar 12 2023 11:05PM
15 0
profile picture
fucintight
Posts: 279 - Karma: 744
get a soldering iron and some of thise flat ptex sticks. ive gotten like 3 deep, see the edge type, coreshots on my wides the past 3-4 weeks and it's saved my ass. costs like $60 and it's a life saver
FranklinTheSkier














I know I already made a thread about this but it’s getting exponentially worse. I contacted emmet and he generously sent me a new ski as warranty, but the problem is It was only sent one ski (most likely because I told him that only one of my skis was damaged at the time), but both my skis are destroyed at this point. I’m most likely going to just buy a new pair of Vishnus next season but in the mean time how do I preserve these and how can I prevent this from happening again in the future?

I counted 14 edge cracks across both skis
2 core shots, one of them being pretty big
edge peeling off at tip
multiple edge dents
top sheet damage is fine idrc

(All of this over the span of around 16 days skiing)
Mar 13 2023 8:30AM
2 0
profile picture
bogust
Posts: 692 - Karma: 7,192
You think that’s bad. These are 2022/2023 skis and Emmet didn’t even warranty this. I just epoxied it and kept skiing

Mar 13 2023 9:01AM
11 2
profile picture
Jammu
Posts: 1796 - Karma: 328
I dont see any warranty cases, just abused skis. Allthought my beated rail/urban skis are in better condition, wouldn’t use them on the slope anymore.
Mar 13 2023 9:55AM
7 0
profile picture
FranklinTheSkier
Posts: 138 - Karma: 380
JammuI dont see any warranty cases, just abused skis. Allthought my beated rail/urban skis are in better condition, wouldn’t use them on the slope anymore.


I never asked for a warranty. Like I said, I made a thread about this before and the people of Newschoolers told me to ask emmet what I should do. I told him the problem and asked for advice and he immediately offered to send a ski in warranty.
Mar 13 2023 10:40AM
10 0
profile picture
Sighman_Fisher
Posts: 78 - Karma: 372
you might have to epoxy the bases to prevent them from rotting but besides that those skis are in very good condition
Mar 13 2023 10:53AM
2 0
profile picture
weastcoat
Posts: 6435 - Karma: 74,259
Those skis are not on life support.
https://www.newschoolers.com/videos/watch/1066853/trim-3397CE02-8B84-49C1-9D84-41B460DF719C-MOV
And neither were these from a few years ago. Planks still had plenty of life. Never broke on me.


your skis aren’t on life support until they don’t slide on snow anymore.
Mar 13 2023 11:01AM
17 0
profile picture
skiP.E.I.
Posts: 7843 - Karma: 22,165
Yeah those still have another season in em. They're just at the point now where you don't have to care about them getting beat up.
Mar 13 2023 11:06AM
8 0
profile picture
skiP.E.I.
Posts: 7843 - Karma: 22,165
P-tex the core shot, file down any pieces of edge sticking out, wax them and go.
Mar 13 2023 11:08AM
4 0
profile picture
olddirty
Posts: 722 - Karma: 2,795
Your skis are going to break if you're hitting rails. That is all
Mar 13 2023 11:25AM
8 0
profile picture
IsaacNW82
Posts: 769 - Karma: 6,693
To prevent this type of stuff, detune edges and keep the bases waxed, that should make some difference.

But honestly at a certain point its worth taking the time to learn to fix stuff with epoxy and a file. Maybe other skis would last somewhat longer, but my bet is you'll wreck any ski you buy eventually. Always clean and sand/wire brush anything you epoxy, let it cure fully, and develop some finesse with a file and you can fix way more than you'd expect
Mar 13 2023 3:00PM
3 0
profile picture
IsaacNW82
Posts: 769 - Karma: 6,693
Oh also make sure to fix delams/edge pullouts quickly before they propagate, and be very careful with were water can get into and freeze. Those two turn small problems into big problems fast
Mar 13 2023 3:02PM
2 0
profile picture
BLandz
Posts: 1678 - Karma: 27,667
I swear posting pics of your busted V’s is just a meme to troll Emmett at this point. Like how the fuck do you kids even mangle your skis like that in the first place, and then ask for warranty? its actually crazy
Mar 13 2023 4:25PM
13 0
profile picture
BLandz
Posts: 1678 - Karma: 27,667
FranklinTheSkierI never asked for a warranty. Like I said, I made a thread about this before and the people of Newschoolers told me to ask emmet what I should do. I told him the problem and asked for advice and he immediately offered to send a ski in warranty.

Then why tf did you make another thread about it lmao
Mar 13 2023 4:27PM
5 0
profile picture
Bio_8
Posts: 236 - Karma: 1,125
jb weld
Mar 13 2023 9:25PM
3 0
profile picture
FranklinTheSkier
Posts: 138 - Karma: 380
BLandzThen why tf did you make another thread about it lmao


I’ve never had damage like this before and since my old thread it’s gotten worse and there are new problems that I dont know how to fix. I used a total of around .5 brain cells to come up with the idea that making another thread on the top skiing chat site would probably be a good idea to find tips/help on my problem. Hopefully that helps you a little.
Mar 13 2023 10:10PM
2 1
profile picture
BLandz
Posts: 1678 - Karma: 27,667
FranklinTheSkierI’ve never had damage like this before and since my old thread it’s gotten worse and there are new problems that I dont know how to fix. I used a total of around .5 brain cells to come up with the idea that making another thread on the top skiing chat site would probably be a good idea to find tips/help on my problem. Hopefully that helps you a little.

Holy christ my bad didn’t realize I was gonna hurt your feelings saying that
Mar 14 2023 10:22AM
1 2
profile picture
rojo.grande
Posts: 1508 - Karma: 12,266
Everyone who rides rails should own an angle grinder or bare minimum a file, and file the absolute piss out of your edges under foot til they’re round. My old vishnus with heavy detunes would go a whole season picking up only a few edge cracks. Don’t be afraid of the detune, ya maybe it doesn’t feel right taking edge off of a new ski but trust it’s your best friend.
Mar 15 2023 10:29AM
11 0
profile picture
WestSystemsGFlex
Posts: 74 - Karma: 426
you are trippin these are brand new
FranklinTheSkier














I know I already made a thread about this but it’s getting exponentially worse. I contacted emmet and he generously sent me a new ski as warranty, but the problem is It was only sent one ski (most likely because I told him that only one of my skis was damaged at the time), but both my skis are destroyed at this point. I’m most likely going to just buy a new pair of Vishnus next season but in the mean time how do I preserve these and how can I prevent this from happening again in the future?

I counted 14 edge cracks across both skis
2 core shots, one of them being pretty big
edge peeling off at tip
multiple edge dents
top sheet damage is fine idrc

(All of this over the span of around 16 days skiing)
Apr 13 2023 10:57AM
2 0
profile picture
WestSystemsGFlex
Posts: 74 - Karma: 426
Vish-shoewith the power of West Systems Gflex Epoxy, those can be as good as new


real asf
Apr 20 2023 10:28AM
2 0
All times are Eastern (-5)