It looks like you are using an ad blocker. That's okay. Who doesn't? But without advertising revenue, we can't keep making this site awesome. Click the link below for instructions on disabling adblock.
Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
Concern about pivot 15 bindings not fully clicking in
I recently got pivot 15s but I think there might be a problem. Whenever I put my boots on and step into the bindings it doesn’t make a loud snappy pop like I would think and the heel piece also doesn’t seem fully locked in. What I mean by that is that the heel piece wiggles back and forth a little bit. also I don’t know if this information helps but my boots have grip walk. If anyone knows if this is an issue or if this is normal I would appreciate if you could let me know. Thanks.
powpatrolsend a vid if you can. pivots click in pretty damp but you should know if your properly in or not
I think I fixed it. All I did was loosen those two screws on either side of the heel piece and that seemed to let the boot have enough room to snap in place
tdollothe white tab does not indicate forward pressure
Yes it does? The manual says to get it lined up with the two black lines and then tighten til you can't easily rotate the heel with the boot in the binding.
Paul.The tab is look’s official way to check forward pressure. Although I think most would agree it’s not the most accurate way to measure fwd pressure
So it's basically vibes and feel?
Is there an easy way to measure elastic travel in a binding on a ski techs bench?
