Member of the Month

partyandBS
December, 2024

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

Look pivots off the track of the heel

profile picture
Stevenkellam1
Posts: 9 - Karma: 35
How do i get my look pivots back onto the track of the heel piece?
Mar 1 2022 1:08PM
1 1
profile picture
Logi
Posts: 388 - Karma: 3,884
Stevenkellam1How do i get my look pivots back onto the track of the heel piece?


Are you talking about the heel piece being able to rotate freely when a boot isn’t clipped in? If so, you can just rotate it back to align with the toe piece, you should hear and feel a click when it’s centered
Mar 1 2022 2:17PM
0 0
profile picture
KCoCM
Posts: 963 - Karma: 8,787
track of heel piece?
Mar 1 2022 2:18PM
0 0
profile picture
Stevenkellam1
Posts: 9 - Karma: 35



Mar 1 2022 2:34PM
0 0
profile picture
Stevenkellam1
Posts: 9 - Karma: 35
I tried Loosening it and tightening it and nothing worked
Mar 1 2022 2:35PM
0 0
profile picture
KCoCM
Posts: 963 - Karma: 8,787
ohh ya ur just wanna give that a couple taps with a good ole hammer

edit: i dont actually know anything about bindings so maybe dont do that but it looks like its all it needs to my eyes lol

**This post was edited on Mar 1st 2022 at 2:43:42pm
Mar 1 2022 2:42PM
3 0
profile picture
Stevenkellam1
Posts: 9 - Karma: 35
Is that all😂
maybe I’ll try a mallet or something or take it to a shop

**This post was edited on Mar 1st 2022 at 2:44:34pm
Mar 1 2022 2:43PM
0 0
profile picture
BradFiAusNzCoCa
Posts: 7153 - Karma: 62,868
How tf you do that??
Mar 1 2022 2:57PM
0 0
profile picture
ericforman
Posts: 722 - Karma: 6,212
Dawg be super careful with your fingers. Pivot heel pieces that are not mounted are basically bear traps.
Mar 1 2022 4:49PM
5 0
profile picture
Stevenkellam1
Posts: 9 - Karma: 35
Thanks for all the comments i got er figured out, had to mess with the spring and it released
Mar 1 2022 4:51PM
2 0
profile picture
Chunderface
Posts: 2537 - Karma: 9,941
just toss it
Mar 1 2022 9:31PM
0 2
profile picture
Paul.
Posts: 1619 - Karma: 11,207
Sounds like you got it figured out, but for anyone else that has this problem - That top part is just a cosmetic plastic cover and can be popped on and off by simply jamming a screwdriver in the crack between it and the lower half of the dildo, and prying it up carefully. It will also come up like this if you loosen the din screw beyond the minimum setting. To get it back in place, just make sure the din screw is tightened enough and then simply push it down and it should click into place. This is also a fun and easy way to customize your pivots if you have multiple pairs to swap parts with




**This post was edited on Mar 1st 2022 at 10:34:53pm
Mar 1 2022 10:30PM
8 0
All times are Eastern (-5)