Member of the Month

KilaTsunami
October, 2024

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

Using busted skis for rail setup?

profile picture
muffMan.
Posts: 2768 - Karma: 26,060
Could this work? For my set up it’s either spending 30 on pvc or try and use a guys free broken canidade 3.0s
Oct 23 2021 10:15PM
2 0
profile picture
CatdickBojangles
Posts: 6200 - Karma: 62,949
How busted is busted?
Oct 23 2021 10:27PM
0 0
profile picture
muffMan.
Posts: 2768 - Karma: 26,060
Like not cracked in half, but just edges basically torn off and some delam
CatdickBojanglesHow busted is busted?
Oct 23 2021 10:30PM
0 0
profile picture
CatdickBojangles
Posts: 6200 - Karma: 62,949
Coleg55Like not cracked in half, but just edges basically torn off and some delam


Use them they will be perfectly fine then.
Oct 23 2021 10:44PM
0 0
profile picture
animator
Posts: 4552 - Karma: 26,250
Coleg55Like not cracked in half, but just edges basically torn off and some delam


That’s fine they’ll slide better lmao
Oct 23 2021 10:45PM
0 0
profile picture
KCoCM
Posts: 963 - Karma: 8,782
is OP meaning to use the busted ski as the thing being slid.. like using the busted skis as the rail?
Oct 23 2021 11:04PM
3 0
profile picture
muffMan.
Posts: 2768 - Karma: 26,060
Damn my b I didn’t even think of that. Yeah like I’ll drill the busted ski into some 2x4s and slide on them instead of some pvc
KCoCMis OP meaning to use the busted ski as the thing being slid.. like using the busted skis as the rail?
Oct 24 2021 1:21AM
1 1
profile picture
theabortionator
Posts: 51645 - Karma: 162,278
Just make sure to round out any existing edges near any missing pieces. If you're just using the, in the yard or random urban fuck it. Edges are overrated if you don't have to turn.
Oct 24 2021 1:24AM
2 0
profile picture
Diento
Posts: 194 - Karma: 618
I've been using my ski's with no edges in the middle and it still works so id say go for it :)
Oct 24 2021 9:43AM
0 0
profile picture
skiP.E.I.
Posts: 7821 - Karma: 21,850
Coleg55Damn my b I didn’t even think of that. Yeah like I’ll drill the busted ski into some 2x4s and slide on them instead of some pvc

Use the busted skis to ski on. Just get some pvc, it will work better. You could try to turn the skis into a rail but with the amount of work it will take and the lumber to get a usable setup it's worth it to buy the PVC. Also assuming the skis are ~ 180 cm, you would end up with a 10'- 12' rail which is pretty short. If you want to do swaps or spins out, a round surface is better than a flat surface anyway.
Oct 24 2021 12:21PM
3 0
All times are Eastern (-5)