Member of the Month

X_MEMESWERVE_XX
March, 2025

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

Help with atomic tracker 16

profile picture
lil.Boye
Posts: 2764 - Karma: 12,498




Anyone familiar with these bindings? Taking off the binding but i can’t get the toebox off the mountingplate. Anyone know how to do this?
4 years ago
1 0
profile picture
cydwhit
Posts: 5077 - Karma: 43,062
The pivot bolt unscrews into two pieces if I remember correctly. One end is a smaller screw that threads into the shaft that then goes all the way through the binding. I remember it being torqued really, really tight, so be carefull loosening it. And when you put it back together, use locktite, you really don't want it working loose while you're skiing.
4 years ago
0 0
profile picture
lil.Boye
Posts: 2764 - Karma: 12,498
cydwhitThe pivot bolt unscrews into two pieces if I remember correctly. One end is a smaller screw that threads into the shaft that then goes all the way through the binding. I remember it being torqued really, really tight, so be carefull loosening it. And when you put it back together, use locktite, you really don't want it working loose while you're skiing.

There isn’t anything to screw on the other side.
4 years ago
1 0
profile picture
cydwhit
Posts: 5077 - Karma: 43,062
lil.BoyeThere isn’t anything to screw on the other side.


I'm an idiot, sorry, was confusing the frame bindings I've take apart.

Here's a usefull TGR thread about this issue: https://www.tetongravity.com/forums/showthread.php/262352-help-removing-salomon-guardian

Just don't strip that screw head, be very carefull with it,
4 years ago
0 0
profile picture
tomPietrowski
Posts: 7288 - Karma: 18,673
That is the original. Its just a posi screw at one end. The bolt (round silver part in that photo) that pivot screw goes into is supposed to be fix firmly in the toe plate, but they often spin which make it really hard to remove. If the bolt is spinning you will probably need to drill it out and replace the pivot bolt if they want to reuse the bindings.
lil.BoyeThere isn’t anything to screw on the other side.
4 years ago
0 0
All times are Eastern (-4); Currently it's 6:55PM