Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
Remounting in the same holes
Posts: 7
-
Karma: 74
Yew, just wondering if its ok to screw bindings back into the same holes if they've been removed once? Do you need to put wood glue in the holes?
Posts: 6430
-
Karma: 60,413
Yes it's fine to reuse the same holes, just take care screwing the bindings back in so you don't cross the thread. As long as you feel the screw bite and feel solid once it's all the way down you're good. I always use epoxy rather than wood glue for remounts, purely because it makes me feel better but wood glue should be fine.
Posts: 765
-
Karma: 4,854
what twig already said. i always use a normal hand screwdriver when using old holes and i've always used just wood glue.
Posts: 2255
-
Karma: 1,250
just to add on to what's said above, if you do end up crossing the thread on a hole, end up with a spinner or pull them out after remounting you can always still helicoil or metal insert the holes to get the bindings back on the skis in the same place.
All times are Eastern (-5)
