Member of the Month

hi_vis360
November, 2024

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

Problem with DIN tick mark on bindings

profile picture
Domski1856
Posts: 93 - Karma: 1,334
Hey NS, I have a slight dilemma. My marker jesters work just fine OTHER than the fact that the white tick mark that shows what your dins are set at has faded and now there’s just an indentation where the white painted tick used to be. I can still adjust my dins but it’s a bit of a hassle to shine a flashlight at the right angle to see the indentation instead of just having a visible white tick mark to set my dins. How would one go about to fix this problem? Thanks guys

**This thread was edited on Dec 6th 2017 at 6:29:56am

**This thread was edited on Jan 24th 2018 at 4:43:25am
Dec 6 2017 3:20AM
1 0
profile picture
Domski1856
Posts: 93 - Karma: 1,334
The simplest way of fixing this i could think of would be to remove the transparent plastic/glass piece that covers the din settings and just color in the indentation with a metallic sharpie...
Dec 6 2017 3:23AM
1 0
profile picture
Domski1856
Posts: 93 - Karma: 1,334
Bump
Jan 24 2018 4:41AM
0 0
profile picture
mmccarthy81
Posts: 413 - Karma: 755
Domski1856The simplest way of fixing this i could think of would be to remove the transparent plastic/glass piece that covers the din settings and just color in the indentation with a metallic sharpie...


This sounds pretty effective, otherwise see if you could order on the piece where the line wore out from marker. Not sure if this is even possible though.
Jan 24 2018 9:28AM
0 0
profile picture
Domski1856
Posts: 93 - Karma: 1,334
Do you know how to remove the plastic so I can paint the tick mark in?
Jan 24 2018 1:02PM
0 0
profile picture
.nasty
Posts: 10582 - Karma: 11,183
get new bindings. Jesters are junk anyway.
Jan 24 2018 1:07PM
0 0
All times are Eastern (-5)