Member of the Month

profa_212
July, 2025

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

Edge pulling out underfoot

profile picture
jellomellow
Posts: 961 - Karma: 3,562
Hey guys I've got a tiny bit of edge pulling out underfoot and was wondering what i should do. I'm heading out to rely tomorrow and was wondering if these would be good to ski on or if it would reck the ski.

Pics as usual



I know that this should be in the gear thread but i need answers quickly.
10 years ago
7 4
profile picture
jellomellow
Posts: 961 - Karma: 3,562
Also forgot to mention that when i try to push it back into place it will not budge.
10 years ago
0 0
profile picture
Jon_Taffer
Posts: 1375 - Karma: 5,386
Fuckin way she goes buddy. Sadly there's not much you can do, push it back in as much as you can and ski till it pops out. If it gets sketchy just rip it out. Happens to 90% of park skis
10 years ago
5 0
profile picture
edai
Posts: 4995 - Karma: 4,701
Jon_TafferFuckin way she goes buddy.


Fuckin way she goes buddy.
10 years ago
0 3
profile picture
a_burger
Posts: 5258 - Karma: 21,145
cut the edge at the top of the bulge and then push it back in. it will probably pull out again though but at least you could ski on it
10 years ago
0 0
profile picture
clorox
Posts: 1728 - Karma: 4,867
Heat up the edge, put some 2 part epoxy in there and clamp it shut with a vice for 24-48 hours. If you don't have the tools or epoxy, a shop should do it for like $10.
10 years ago
2 1
profile picture
SKIU4EA
Posts: 2388 - Karma: 2,087
https://www.newschoolers.com/news/read/How-Fix-Broken-Edge

this doesn't always work, but it's worked for me a few times if you're patient with your work and know your way around tools
10 years ago
0 0
profile picture
jellomellow
Posts: 961 - Karma: 3,562
Bump would these be ok to ride on because of the edge?
10 years ago
0 0
profile picture
Static
Posts: 8598 - Karma: 3,972
they arn't gonna explode your fuckin' foot off. if you wanna ski around on your busted ski with it hooking and grabbing go for it, waste a day and then buy some new skis.
10 years ago
0 0
profile picture
Hoodliving
Posts: 1033 - Karma: 1,877
Whenever I bust an edge like that I will swap feet so that it will be my less dominant uphill ski so that I don't place it into the snow as much, usually works fine it'll be a little grabby but its a handful of turns and your used to it. AVOID ROCKS at all costs one base shot can rip that edge out.
10 years ago
0 0
profile picture
razors-chaz
Posts: 2255 - Karma: 1,250
SKIU4EAhttps://www.newschoolers.com/news/read/How-Fix-Broken-Edge

this doesn't always work, but it's worked for me a few times if you're patient with your work and know your way around tools


saw through the edge with a fine blade hacksaw then do this is your only real option
10 years ago
0 0
profile picture
moosevision
Posts: 140 - Karma: 214
Cut out the section that's sticking out with a hack saw. Then file the two ends inward, don't bend them, file the actual metal on a slant toward the sidewall, that way they don't catch when you're on edge and you also don't weaken the bonds still holding the good sections in.. Finally just epoxy the edge less section to keep it water tight. The epoxy will probably crack or fall out in time, just re do it when that happens.
10 years ago
0 0
All times are Eastern (-4); Currently it's 0:20AM