Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
Look pivots to marker jesters
Posts: 65
-
Karma: 31
So I bought I pair of surface new life's and they've been drilled once already for a p18. Is there a way to mount a marker jester without redrilling? will I have some concerns with the screw pattern on the toe and heel? Thanks guys give me some suggestions.
Posts: 13785
-
Karma: 1,956
Im pretty sure that none of the holes will line up since the jester/griffon is based off a wider mount pattern than the FKS. You should be able to remount in the same position without any problem. Worst case scenario is that you would have to move the mount +/- 1cm.
Posts: 4103
-
Karma: 7,001
same thing happened to me except the skis were drilled for the markers. my looks then had to be mounted -1 from where i wanted, but i love the way they ride.
Posts: 1642
-
Karma: 868
I went the other way, Jesters to FKS.
You can mount in exactly the same spot, assuming the mount pattern hasn't changed.
2 of the toe holes line up.
The other 2 have to be redrilled and are borderline close to the Jester holes but held up fine for me. The FKS mount is actually wider than the Jester.
The heels are 100% different, miles apart, no problems there.
This is all assuming you're going to mount for a boot with a very similar BSL to the one that was on there.
All times are Eastern (-5)
