Member of the Month

KilaTsunami
October, 2024

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

Breaking in fulltilts

profile picture
Guggs
Posts: 189 - Karma: 386
So I searched around the site and couldn't find anything in how people broke in there fulltilts. Or in general boots. Just curious as to what everyone does. I've heard that fulltilts are no fun to break in but are great afterwards.
Nov 10 2015 4:41PM
6 0
profile picture
Swandog7
Posts: 4955 - Karma: 9,021
Did you get them heat molded?
Nov 10 2015 4:42PM
0 0
profile picture
eheath
Posts: 61601 - Karma: 123,020
Heat mold and ski, thats all you gotta do.
Nov 10 2015 4:47PM
2 0
profile picture
Swandog7
Posts: 4955 - Karma: 9,021
eheathHeat mold and ski, thats all you gotta do.


This. Didnt get mine heat molded last time I got new boots and it wasn't that fun. Took about 7 full days to get them completely broke in. This time I didnt make that mistake. If you haven't done this I highly recommend it. Gets a better fit in the boot as well.
Nov 10 2015 4:55PM
0 0
profile picture
J3P.CINEMA
Posts: 34 - Karma: 354
when i sell full tilts i always sell them than heat mold
Nov 10 2015 6:42PM
0 0
profile picture
NMMedia
Posts: 982 - Karma: 1,700
eheathHeat mold and ski, thats all you gotta do.


can confirm
Nov 10 2015 6:48PM
0 0
profile picture
Guggs
Posts: 189 - Karma: 386
Havnt got them heat molded. I head some people just heat them up with a hair dryer and calmp em down tight. any advice??
Nov 11 2015 2:19AM
0 0
profile picture
abaer
Posts: 58 - Karma: 55
GuggsHavnt got them heat molded. I head some people just heat them up with a hair dryer and calmp em down tight. any advice??


I would suggest not doing that! Go to a shop that has the equipment to mold intuition liners. If you got a correct fit you will want to use some boot fitting AIDS when you get the molded like a tie cap.
Nov 11 2015 7:24AM
0 0
All times are Eastern (-5)