Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
Creating supports for a cut in half fatty tube
Posts: 4955
-
Karma: 9,021
So i recently acquired a fatty tube (not gonna say how i got it) and I'm tempted to cut it to get 20ft out of it instead of 10ft. Its 12inches in diameter so if i cut it it would stand 6inches high (do the math). I need to be about 14inches high to match my lip. How do I make supports for such a wide cut in half tube. K+ for answers as this cult is dead
Posts: 7313
-
Karma: 49,163
All times are Eastern (-5)