Member of the Month

hi_vis360
November, 2024

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

2015 Bent Chetler Binding Mount

profile picture
chontynz
Posts: 16 - Karma: 46
Hey guys I just got myself a pair of 2015 Atomic Bent Chetler's 185cm, and was looking some advice on mount point. I am 5'10 and 180lbs and like to ski mostly in a forward stance, skiing in powder and dropping off some small features when I get the option. I do the occasional switch skiing but mostly enjoy myself staying forward. I was thinking about a -2 position but was hoping to get a bit of advice?
May 16 2014 2:55AM
8 2
profile picture
LC.
Posts: 5952 - Karma: 2,423
Measure everything up, mark some lines for centre of effective edge, centre of sidecut, true centre. Compare those lines to the recommended mount, make a judgement call yourself.

Up until now the recommended line has been -2.5cm from true centre and they ride well there; don't stray too far from the it. Mine are -3cm from true and I love them. A friend mounted his at -4 or -4.5cm and regretted it.
May 16 2014 4:26AM
1 0
profile picture
Twig
Posts: 6421 - Karma: 60,334
I rode my old ones at -1.5cm because I genuinely did ride them switch half the time. As mentioned above, don't go more than a cm from the recommended, since it is actually the best mount. If you want to ski switch in pow a lot, 1cm forward, if you don't at all, maybe 1 back.

Also, make sure you measure yourself, topsheet mounting lines are frequently way off where they are meant to be.
May 16 2014 6:45AM
1 0
profile picture
Nippletron
Posts: 148 - Karma: 670
NZphysioHey guys I just got myself a pair of 2015 Atomic Bent Chetler's 185cm, and was looking some advice on mount point. I am 5'10 and 180lbs and like to ski mostly in a forward stance, skiing in powder and dropping off some small features when I get the option. I do the occasional switch skiing but mostly enjoy myself staying forward. I was thinking about a -2 position but was hoping to get a bit of advice?


How do they measure? They 185 tip to tail straight measure? Or somewhere around 182?
May 16 2014 8:53AM
0 0
profile picture
kung_powpow
Posts: 1990 - Karma: 3,671
NippletronHow do they measure? They 185 tip to tail straight measure? Or somewhere around 182?


Not sure about the 2015 chetlers but my 2013 chetlers measure 1cm short. They're 192cm and tip to tail pull is 191cm.
May 18 2014 11:24AM
0 0
profile picture
.nasty
Posts: 10582 - Karma: 11,183
they measured around 183 when I mounted mine. I mounted them ay -2cm from center and loved it. Don't go any further back than that, they're an extremely center-directional behaving ski.
May 18 2014 2:43PM
2 0
profile picture
chuckmarty
Posts: 344 - Karma: 448
Got my 185's mounted at -2.5 by nyles. They ski so freakin well. And yeah, the measurements on the top sheet are off on these skis.
May 18 2014 2:50PM
0 0
profile picture
.nasty
Posts: 10582 - Karma: 11,183
chuckmartyGot my 185's mounted at -2.5 by nyles. They ski so freakin well. And yeah, the measurements on the top sheet are off on these skis.


yeah I think I might've gone at -2.5 myself haha. don't remember exactly (but either way they will feel the same, it's a good spot)
May 18 2014 2:53PM
1 0
profile picture
D3NZ3L
Posts: 556 - Karma: 37
Center mounted pow skis are way fun. I would definitely recommend center if you park skis are center also because its much easier having your whole quiver mounted the same. Tops go like 2.5cm back from true center.
May 18 2014 3:35PM
0 2
profile picture
kung_powpow
Posts: 1990 - Karma: 3,671
From the man himself in a previous thread

"I would say 2 or 2.5 behind center. We are very similar in size, and I personally ride mine at 1.5 behind center.. I've ridden a pair at center, 2, 2.5, and 1.5, and loved them all, but for all around/ all the time, 2 was the way to go. Hope that helps my friend, and thank you very much for the support. Hope you enjoy them.
Cheers,

CB

https://www.newschoolers.com/forum/thread/501324/Help--Atomic-Bent-Chetler---
May 18 2014 9:07PM
1 0
All times are Eastern (-5)