Member of the Month

hi_vis360
December, 2024

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

Small Ski Repair Job (ON3P Jeffrey)

profile picture
49566738265
Posts: 0 - Karma: 7,704
Somewhere in my moving of items around my garage I cleanly sliced the base of my ski as seen here:

Click for larger image

The base was sliced clean and presses back into place perfectly. I'm going to use some small rubber clamps to get a tight, clean seal when I adhere them back together, but I'm not 100% sure what epoxy I should use for this. I'm not sure what materials are exposed and I don't want to do it twice. Any tips?
Mar 24 2014 6:36PM
8 1
profile picture
NinetyFour
Posts: 8650 - Karma: 13,411
A 'marine' grade epoxy would work best. The repair plan you have layed out sounds perfect. As far as materials go, all that has been exposed is some tipfill (same material as your base, just thicker) and some fiberglass. So if it isn't 100% sealed, you won't have to worry about the core drawing moisture in through there anyways.
Mar 24 2014 7:35PM
1 0
profile picture
skiRay
Posts: 7558 - Karma: 926
good stuff here.

maybe even throw a duct tape wrap around the tip (or tail) after the epoxy sets for another water barrier
Mar 24 2014 7:59PM
0 1
profile picture
s-hand
Posts: 1334 - Karma: 1,800
I had a sort-of similar problem with my JMOs.  Contacted the company for advise and they recommended West Systems G-flex epoxy.  But truthfully, any good 2-part epoxy will probably do the trick.
Mar 24 2014 11:30PM
4 0
profile picture
RudyGarmisch
Posts: 25443 - Karma: 13,844
Important - clean very well so that the bond is strong, and stick something between the clamps and the ski so your clamps don't get stuck to the ski! You can scrape or sand off excess epoxy if you go overboard. A small drop will go a long way if the correct pressure is used, go find some hpde at tap plastics or a hobby store for good clamp blocks. Relevant article for plastic choice: http://www.eplastics.com/Polyethylene-Adhesives-Glue
Mar 25 2014 6:45PM
0 0
profile picture
49566738265
Posts: 0 - Karma: 7,704
Already done guys, it's super easy stuff. Just was looking for an epoxy recommendation for that material. Thanks!
Mar 25 2014 8:19PM
0 0
All times are Eastern (-5)