Member of the Month

KilaTsunami
October, 2024

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

Look pivot 14 (2005 model year)

profile picture
bigskier1010
Posts: 126 - Karma: 187
Hello NS. Tuning up this week getting ready for season . My park and beater boards have pivots on them, I just noticed the heel piece on one ski is for s lot of play in it . How do I remove the top plate to access /,inspect mount screws? I believe I may have pulled a mount screw out and not noticed last year .
Nov 15 2013 6:12PM
4 0
profile picture
japanada
Posts: 13784 - Karma: 1,957
Do you have the FKS/Pivots with the 360 degree heel or the pivot/power bindings with the 200 degree pivot heel?

I didnt think there was a fks140 in 2005, only the 155/180 race versions.
Nov 15 2013 6:19PM
1 0
profile picture
bigskier1010
Posts: 126 - Karma: 187
I have the "look pivot 12". I bought in May of 05, they may be the 04 model year. . I Don't recall...are you familiar ?
Nov 16 2013 1:09AM
0 0
profile picture
LC.
Posts: 5952 - Karma: 2,423
Back out the forward pressure screw all the way then pull it off to the back hard, but you've probably just got play in the heelpiece.
Nov 16 2013 4:28AM
1 0
profile picture
freeskibum82
Posts: 6355 - Karma: 5,055
the heel piece screw will slide it off the track, then there will be four screws under that. if they are truly loose, you should take the ski to a shop so they can either helicoil it or remount them.
Nov 16 2013 8:31AM
0 0
profile picture
last_tango
Posts: 2635 - Karma: 2,665
Are these what we are talking about?
Click for larger image
I remember after a while the track plate would get loose and they wold need some tightening. The track plate would have some play to it after the three years I rode on them.
Nov 16 2013 11:04AM
1 0
profile picture
bigskier1010
Posts: 126 - Karma: 187
Yes, looks like my model, mind are all silver though . There's always been some play/ wiggle in the track plate, but this one is quite excessive . I'll check them out tonight and see what I find . Thanks for help.
Nov 16 2013 4:02PM
0 0
profile picture
bigskier1010
Posts: 126 - Karma: 187
Thanks for guide guys. No tear out, but loose screw mount screws. Needs epoxy and remounted .
Nov 17 2013 12:35PM
0 0
All times are Eastern (-5)