Member of the Month

partyandBS
December, 2024

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

Binding Remount Question

profile picture
seb_hofmann
Posts: 155 - Karma: 1,453
Already searched for and couldnt find anything quite the same.

I took my bindings off my Line Afterbangs to redo the graphics and i was planning to just put them right back on at the end of the process but my friend says it might now be safe/they may tear out. Is this a problem i should worry about? should i remount a cm back or will they be fine?

+k to useful answers
Oct 22 2013 5:10PM
11 1
profile picture
tomPietrowski
Posts: 7220 - Karma: 18,095
They will be fine to put back into te same holes as long as you did not destroy taking them out. So long as you know how to use a screwdriver you will be fine. Use some wood glue and make sure you don't over tighten and strip the screws.
Oct 22 2013 5:12PM
3 0
profile picture
corona
Posts: 12811 - Karma: 32,916
absolutely fine. remounting them really close to the original holes would be worse for sure.
Oct 22 2013 5:15PM
1 0
profile picture
seb_hofmann
Posts: 155 - Karma: 1,453
thank ya both
Oct 22 2013 5:55PM
0 0
profile picture
VD.
Posts: 4054 - Karma: 4,565
Just going to reiterate, providing the threads are intact, wood glue alone or with some steel wool for added bite should do the trick. Also make sure to use wood glue, not epoxy.
Oct 22 2013 7:08PM
2 0
profile picture
Pikachu.
Posts: 1290 - Karma: 1,641
just wondering why the no epoxy?
Oct 22 2013 7:36PM
1 0
profile picture
Blurst
Posts: 13577 - Karma: 10,169
itll make your momentum wrong.
Oct 22 2013 7:39PM
0 0
profile picture
seb_hofmann
Posts: 155 - Karma: 1,453
yeah why is that? isnt the entire ski held together with epoxy?
Oct 22 2013 7:42PM
0 0
profile picture
profa_212
Posts: 9004 - Karma: 37,355
I think a lot of epoxy expand? And wood glue doesn't? Idk I don't remember woods shop very much.
Oct 22 2013 8:48PM
0 0
profile picture
tomPietrowski
Posts: 7220 - Karma: 18,095
If you use epoxy an ever need to take the binding off again then it will destroy the holes. The good thing with wood glue is it will hold but also let the screw come out safely when needed.
Oct 23 2013 3:16AM
1 0
profile picture
LC.
Posts: 5952 - Karma: 2,423
In theory yes, but I've done it a lot with no issues. Try wood glue first and if any don't tighten fully then use 24 hour epoxy with fibreglass roof insulation (heavy mix of fibreglass), snug them down, leave to set then tighten fully.
Oct 23 2013 6:38AM
2 1
All times are Eastern (-5)