Member of the Month

KilaTsunami
October, 2024

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

SPK toe rubber placement

profile picture
Dustin.
Posts: 13839 - Karma: 7,704
I pulled the liners out of my original SPKs to dry them out and the yellow SCS toe cushion go dragged to the heel in the process. I can't figure out how to orient these again so my boot fits properly. Anyone know how these are supposed to go?
Dec 30 2012 3:04PM
1 0
profile picture
tomPietrowski
Posts: 7145 - Karma: 17,457
Do you mean the rubber that is in the toe of the shell. that is bonded into the shell so should not come out

There is the yellow rubber pad which sits under the heel, is it that?

Is there a hole in the toe of your boot?
Dec 30 2012 3:51PM
0 0
profile picture
ejm
Posts: 794 - Karma: 196
not sure if this is the same as the foam piece in the heal area, but i ripped it out by accident, just put abit of super glue on it and its held for over a season now.
Dec 30 2012 5:43PM
0 0
profile picture
Dustin.
Posts: 13839 - Karma: 7,704
It's the yellow piece shaped as if it should sit in the heel. I have original SPKs and there is a red rubber piece permanently placed in the heel and nothing in the toe box. I don't know how to place the yellow piece for the proper fit.
Dec 31 2012 11:35AM
0 0
profile picture
Dustin.
Posts: 13839 - Karma: 7,704
Actually, the bottom of my liners are stained red an yellow so I think I figured it out. It looks like it fills out your arches. God I need new boots...
Dec 31 2012 11:37AM
0 0
All times are Eastern (-5)