Member of the Month

KilaTsunami
October, 2024

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

Marker Griffons Movement

profile picture
adamwhit8
Posts: 444 - Karma: 11
So, here is my dilemma guys.
I just got some new full tilt boots that are 310mm bsl. However, in attempting to lock into my skis, I found that the length is a little to small (barely reaching) to hold the binding down. So -> the boot is too small in length for what the current marker griffon I have are set at. Now, I have remounted my ar7s twice already, and avoiding a 3rd would be ideal. I heard that the griffons have some slide room, so if anybody could help to describe how i could attempt to make the bindings bsl a bit smaller would be much appreciated!

+k for help thanks guys.
Dec 1 2012 4:43PM
1 0
profile picture
DBL
Posts: 1405 - Karma: 2,218
Its pushed all the way up? You may unfortunately be forced to re mount
Dec 1 2012 5:00PM
0 0
profile picture
adamwhit8
Posts: 444 - Karma: 11
no its in the middle at the rear, im just unsure of how to slide it if you know what i mean, so no its not pushed all the way up
Dec 1 2012 5:15PM
0 0
profile picture
DBL
Posts: 1405 - Karma: 2,218
There is a screw at the back that is parallel to the ski that moves the binding forwards/backwards on the track, use thus to adjust accordingly to the ski
Dec 1 2012 5:20PM
0 0
profile picture
adamwhit8
Posts: 444 - Karma: 11
Just tried it and the entire binding came off the track :\\\ haha, what do i do now? im not sure how to tighten it or loosen it when it is on the track?
Dec 1 2012 6:00PM
0 0
profile picture
adamwhit8
Posts: 444 - Karma: 11
bump
Dec 2 2012 1:02PM
0 0
profile picture
jalty03
Posts: 61 - Karma: 37
when you say remount do you mean drilled two sets of holes?
and why did you have this done?
i would take them to a shop and see what they say.
note: every time you get new boots you should take them in to get teched to your skis.
Dec 2 2012 1:17PM
0 0
profile picture
TGOD
Posts: 53 - Karma: 21
the fella who mentioned the screw in the back is correct in that this is your only option left. Put your booth in the binding, then screw that motherfucker tight! ive done this before so if your entire binding is falling off when you do so, you may want to consider killing whoever sold you those bindings
Dec 2 2012 7:00PM
0 0
profile picture
adamwhit8
Posts: 444 - Karma: 11
the binding just slid off of the track, i dont think that it is the biggest issue? or am i screwed haha?
Dec 4 2012 3:38PM
0 0
profile picture
rwalk
Posts: 442 - Karma: 36
It's made to come off the track just bring it to a shop
Dec 4 2012 5:18PM
0 0
profile picture
adamwhit8
Posts: 444 - Karma: 11
yeah i thought for sure it was, im just gonna bring it in yeah
Dec 4 2012 8:52PM
0 0
All times are Eastern (-5)