Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
Bern Watts/Baker question
Posts: 917
-
Karma: 90
I normally wear my goggles under my helmet. Can I still do that with the knit liner in a Bern Watts or Baker? It looks like the front of the liner would get in the way, but I don't have one at my disposal to test it out. Anyone have any first hand insight? thanks
Posts: 476
-
Karma: 169
If you're wearing your goggles under your helmet than I
Posts: 476
-
Karma: 169
*would assume that you're wearing a hat under the helmet too? I wear the watts without the liner and a beanie underneath with goggles under the helmet and it fits great with the goggles I have (EG2, Smith Phenom, IO). It might not fit with the liner in but if you have a ski shop near you it's worth it to go and try it on
Posts: 917
-
Karma: 90
I was just wondering if it worked with the liner. it looks like theres too much liner hanging down on the forehead/temples to have goggle straps go under it.
Posts: 303
-
Karma: 417
just tried with my watts, the liner doesnt get in the way too much, just a little bit, but nothing to actually effect you
Posts: 263
-
Karma: 44
I did it with mine, did not have that much of a gap, I still rocked mine with out the liner. Just do what works for you.
Posts: 3226
-
Karma: 6,840
It works fine, but not as well as without the liner in. Also, it will probably be a tight fit, since you will have a hat and liner.
All times are Eastern (-5)
