i bought some 08/09 hot doggers and i've already replaced one buckle on the right foot, however in the last month two buckles broke on my left boot (lower and middle) now normally this wasn't a problem to swap them out but the screws wont budge and i took them to my local ski shop and they said the screws wont move either
when they tried moving them the screws appeared to be made of plasticine they were that soft they rounded out as the screw driver turned
they had to be drilled out and now the bottom hole for the cable is too big and i may have to drop money which i dont have on new boots
could i use 2 washers either side to stop the screw holding the lower cable from falling through?
i love full tilt but the last couple of weeks have dented my confidence in them :/