Member of the Month

KilaTsunami
October, 2024

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

Editing Question?

profile picture
TravelsTI
Posts: 1000 - Karma: 353
For those of you that are good with the motion graphics this question is for you. Below is video of a Barrel being branded and I am looking to have the companies logo rise out of the brand marking and come up turning counter clockwise until it is parallel with the screen. I am working with Motion 5 ( I do not have AE) which I am fairly new too. Anybody have any good tutorials or ideas on where to start. Thanks for the help.
 
Feb 25 2012 8:05PM
0 0
profile picture
TravelsTI
Posts: 1000 - Karma: 353
anybody?
Feb 26 2012 7:06PM
0 0
profile picture
123+ski
Posts: 2832 - Karma: 581
Haven't used motion 5, but in final cut 7 you could just take the logo, imported as a jpeg, and then put it in a new video track starting when the branding iron is lifted. Then under the motion tab you could adjust the center, rotation, and scale so that it would be lined up. After that its just a matter of setting the final position, rotation, and size (unless you want it to do things at different rates, then you will need intermediate points). I'm assuming you have final cut x, and I am not sure if it is the same
Feb 26 2012 8:28PM
0 0
All times are Eastern (-5)