Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
Adjusting Marker Griffons?
Posts: 8155
-
Karma: 14,809
Well, A few binding problems recently, I have marker GRIFFONS, when i was trying to clip into my binding i noticed that it could slide along the rail if i applied a bit of pressure, is this supposed to happen? and if not how do i get it to stick in place?
second of all, i used to have a bsl of 317mm, and had my bindings mounted for them, but now I have a bsl of 302mm, and somehow ive tried moving the heel as far back on the rail as it'll go (by sliding with my hand) but it barely fits, how is this possible? :S, is it something to do with one of the screws? as in my old binding i was just to stick a flatea screwdriver under the latch and lift that up, but theres nothing like that with my griffons?
Thanks a lot!
Posts: 1186
-
Karma: 765
For the rail thing, you just have to bend it back. I'm not sure about the other stuff though.
Posts: 1405
-
Karma: 2,218
you have to use one of the screws at the back of the heel piece to move the heel
Posts: 2704
-
Karma: 347
Posts: 3952
-
Karma: 3,057
if your bsl was higher than it is now, moving the heel back was the opposite of what you wanted to do. for you i would recommend taking it to a shop and having them adjust it for you so you dont hurt yourself
All times are Eastern (-5)
