It looks like you are using an ad blocker. That's okay. Who doesn't? But without advertising revenue, we can't keep making this site awesome. Click the link below for instructions on disabling adblock.
Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
first of all i would make it like 12 ft to 3ft donkey dick or 12.5ft to 2.5ft donkey dick, it's not another segment of a rail it's just a little flat spot to give you a little pop to spin off.
What like how to bend it??? You can heat the pipe, place one end of the pipe on a work bench or something, have someone hold the rail down on the bench( with gloves) heat the pipe where it almost meets the work bench, and when it gets hot have someone on the other end of the rail putting his weight down on it, slowly. If you heat it to much or bend it to fast, it will dimple where your bend is. Just take it slow. Or you could take it to a metal supplies and they can or tell you where you can go, and have them bend it. If you do it and the pipe dimples you can sand some of it down and smoother with 80,180,320 grit sand paper, in that order. You could even fill the dimple with bondo/bodywork filler, smooth it down and paint it.