Member of the Month

KilaTsunami
October, 2024

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

Removing stickers

profile picture
BlakeG
Posts: 1450 - Karma: 1,030
How do you remove diecuts off of helmets without damaging the helmet...peeling them isnt working to well and i heard that nail polish remover will melt the plastic of your helmet
any suggestions..
Jul 14 2011 4:00PM
0 0
profile picture
Pastie
Posts: 676 - Karma: 146
Try rubbing alcohol
Jul 14 2011 4:03PM
0 0
profile picture
BuSkiz
Posts: 2240 - Karma: 65
hair dryer/heat gun=profit

if theres any residue use goo-gone
Jul 14 2011 4:08PM
0 0
profile picture
mountainviper
Posts: 1931 - Karma: -3
Try using a heat gun if ya have one or a blow dryer....once you get the sticker off hit it with some rubbing alcohol as stated above
Jul 14 2011 4:08PM
0 0
profile picture
deactivate
Posts: 490 - Karma: 6
Scrape it a little then use wd40 to get rid
Jul 14 2011 4:55PM
0 0
profile picture
deactivate
Posts: 490 - Karma: 6
Of the gunk. It also shines helmet if it's not a dull colour
Jul 14 2011 4:56PM
0 0
profile picture
Keith.
Posts: 967 - Karma: 88
I'd just try peeling it while you drip water into the bit you got up. Then Rubbing alcohol if it doesn't work
Jul 14 2011 6:34PM
0 0
profile picture
james6345789
Posts: 4763 - Karma: 467
I just used a plastic credit card type card and just scrapped the die cut off with that. It was super easy. Does anyone know how to get the residue off?
Jul 16 2011 5:24PM
0 0
profile picture
james6345789
Posts: 4763 - Karma: 467
I didn't see the comments about getting the sticky stuff off.
Jul 16 2011 5:25PM
0 0
profile picture
Jaggy_Snake
Posts: 2287 - Karma: 1,418
Stanley knife blade to get the sticker off and then solvent to clean the area up.
Jul 16 2011 5:40PM
0 0
profile picture
Deluge
Posts: 4401 - Karma: 805
this /thread
Jul 16 2011 6:36PM
0 0
profile picture
RudyGarmisch
Posts: 25443 - Karma: 13,844
Click for larger image
Jul 16 2011 6:56PM
0 0
profile picture
.skiwi.
Posts: 898 - Karma: 40
going to take some stickers off my giro shiv, just wanna make sure that a hair dryer wont melt the plastic? thanks
Apr 2 2012 2:39AM
0 0
profile picture
ShabbaRanks
Posts: 998 - Karma: 65
peel it off then if there is any goo residue get a wet cloth and rub realy hard on the surface till the goo is gone. works every time
Apr 2 2012 2:57AM
0 0
profile picture
.skiwi.
Posts: 898 - Karma: 40
thanks
Apr 2 2012 3:31AM
0 0
All times are Eastern (-5)