A quick word on blocking ads
It looks like you are using an ad blocker. That's okay. Who doesn't? But without advertising revenue, we can't keep making this site awesome. Click the link below for instructions on disabling adblock.
Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!
when i built mine, i only bent it in 2 foot increments. for example.
1. make frame with the taper/design you want
2. anchor beginning of rail very securely( with a hex bolt, not just screws) it also helps to do the same at the end
3. SLOWLY insert screws over a 10 day span going section by section- if you need to, brace the screws by inserting bolts or screws flush to the edge of material being bent, just so that the driven screws are not being yanked out of position.
4. make sure you use a rope and precisely measure from end to end of rail, in clean curves, to project the most accurate cut of grinding material.
i will add pictures in a bit(from paint, not actual project)
once again, DO NOT RUSH the process, in compliance that the material does not handle brute, jerking motions. peace
