Restless — An Alex Hall Portrait (Full Film) | Faction Skis

Member of the Month

KilaTsunami
October, 2024

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

Stripped DIN Screw?

profile picture
EaStCoAsT14
Posts: 16 - Karma: 10
Okay, somehow in my PX12 Jib Ti's, I have managed to strip the head of the screw that controls the DIN setting in the heel piece. This means that there are no threads on top for a screwdriver to lock into and tighten, and I can't get the setting past a 9.5. The good part is there are threads still there so i can loosen it and get the part out if i need too. Anyone think Look would make a replacement part for this, or is this even possible to replace?
Mar 24 2011 12:32AM
0 0
profile picture
Pipe_Munky
Posts: 10888 - Karma: 2,184
not possible to replace unless you replace the entire heel piece.

you should have used a posi driver bit instead of a phillips head to adjust it
Mar 24 2011 9:24AM
0 0
profile picture
alexg1687
Posts: 1505 - Karma: 1,581
On that binding you should be able to use an allen key. Check just outside the thread...it should be a hexagonal (or similar) shape.
Mar 24 2011 10:07AM
0 0
profile picture
LC.
Posts: 5952 - Karma: 2,423
8mm hex key, or Philips 3, not a Pozi 3. Engage the heelpiece before you turn it, it'll be easier and you can lean into it too to keep the driver in place.
Mar 24 2011 10:47AM
0 0
profile picture
monkatizer
Posts: 4704 - Karma: 1,518
just weld a small screwdriver to uit
Mar 24 2011 12:09PM
0 0
profile picture
Mt_Baker_Man
Posts: 2012 - Karma: 105
this. lol.
Mar 24 2011 1:19PM
0 0
profile picture
EaStCoAsT14
Posts: 16 - Karma: 10
ok thanks for the help guys
Mar 24 2011 2:48PM
0 0
profile picture
Mr-conutco
Posts: 327 - Karma: 26
Mine was like this too on my PX's i just used an allen wrench to get it and it worked amazingly!
Mar 24 2011 3:43PM
0 0
All times are Eastern (-5)