Member of the Month

hi_vis360
November, 2024

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

P tex on topsheet

profile picture
CallMeMoonman
Posts: 23 - Karma: 10
can i use p tex to the top sheet on my skis cuz they have a minor chip on them
Feb 24 2011 4:51PM
0 0
profile picture
monkatizer
Posts: 4704 - Karma: 1,518
is ur core exposed?? if it is, then i would try it, if its not theres no need to worry, its a chip
Feb 24 2011 4:58PM
0 0
profile picture
rozboon
Posts: 1642 - Karma: 868
If you can see core or stringy bits of fibreglass then put a bit of resin/2-part epoxy on it to seal it otherwise water can get into your core.

If it doesn't go to the core... who cares. Battle scars! Somewhat smashed up skis look good IMO.
Feb 24 2011 5:44PM
0 0
profile picture
_steffen_
Posts: 904 - Karma: 133
p-tex will chip off quite easily if you use it on the topsheet. If the chip is down to the core then dripping a lil it of p-tex in the hole will help it from getting worse. if the p-tex you drip on isnt flush with the topsheet then it will chip off quite easily. if at all possible use epoxy its perfect for topsheet chipping. im pretty sure they sell clear epoxy at home depot
Feb 24 2011 6:46PM
0 0
profile picture
Whale
Posts: 226 - Karma: 16
No need to do anything it is to fiberglass.
Feb 24 2011 7:30PM
0 0
profile picture
AKilness
Posts: 364 - Karma: 246
yea or jb weld i think could work. never done it but thats what i thought of. but really who cares about little chips as long as its not to the core
Feb 24 2011 9:36PM
0 0
profile picture
rozboon
Posts: 1642 - Karma: 868
Sometimes you get bits of the weave that weren't saturated in resin when the ski was built, or for whatever reason... they stick out like frayed bits of string and will wick water. Considering it only takes 10 seconds to put a blob of epoxy on them... better safe than sorry.
Feb 24 2011 10:41PM
0 0
profile picture
hemlockjibber8
Posts: 5983 - Karma: 3,602
3rd gen k2 public enemies. heavy as fuck
Feb 24 2011 11:15PM
0 0
profile picture
huge-go
Posts: 1451 - Karma: 33
I'm pretty sure jb weld is fully rigid, so as soon as the ski flexes the repair would pop right out. Like people were saying, get epoxy if you're really worried.
Feb 25 2011 2:05PM
0 0
profile picture
Mr.Huck
Posts: 6096 - Karma: 14,902
This is correct.  Epoxy is the ticket. 
Feb 25 2011 4:19PM
0 0
All times are Eastern (-5)