Restless — An Alex Hall Portrait (Full Film) | Faction Skis

Member of the Month

KilaTsunami
October, 2024

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

How to cut down poles

profile picture
hyphy8
Posts: 119 - Karma: 16
yoo how do i cut down my poles?
Dec 31 2010 4:14PM
0 0
profile picture
TheHamburglar
Posts: 3895 - Karma: 3,315
Click for larger image

but seriously, soak the grips in boiling water to loosen the glue, pull em off, then get a hacksaw and do work.
Dec 31 2010 4:29PM
0 0
profile picture
Otter.
Posts: 1161 - Karma: 84
soak the grips in hot water.
pull the grips off - you can put the grip in a door and close it and pull it off.
pole cutter for a clean even cut. hacksaw if you don't have a pole cutter

Dec 31 2010 4:35PM
0 0
profile picture
teleTay
Posts: 2320 - Karma: 186
watch 4frnt tech talk
Dec 31 2010 4:56PM
0 0
profile picture
General_Ripper
Posts: 3327 - Karma: 189
Has anyone ever done composite poles with out totally ruining them?
Dec 31 2010 5:18PM
0 0
profile picture
dispatchQ_main
Posts: 2619 - Karma: 629
I just did yesterday , cutting was fine (much like a hockeystick) but the grips on mine were alot higher quality , it took about 15 min per pole to get the grip off ( with a heat gun vice and errrry tool youde ever need) but when i went to put them back on the grip was constructed differently then most poles ive used before and i could only get it on about half way. You cant tell but i wanted to cut down 4 in and only ended up with 2 in ...
Dec 31 2010 6:34PM
0 0
profile picture
all-i-do-is=ski
Posts: 700 - Karma: 248
i did mine yesterday before i went skiing. But just put the grips in boiling water pull them off and use a pipe cutter.
This is mine
Click for larger image
Dec 31 2010 7:00PM
0 0
profile picture
General_Ripper
Posts: 3327 - Karma: 189
thanx +k
Dec 31 2010 7:21PM
0 0
profile picture
Otter.
Posts: 1161 - Karma: 84
this.
Dec 31 2010 7:37PM
0 0
profile picture
Peter.
Posts: 23796 - Karma: 13,014
if you don't have a pipe cutter you can go to any hardware store and just ask them if you can use theirs, or if they can do it for you. they should be cool about it
Dec 31 2010 7:48PM
0 0
profile picture
dmc12380
Posts: 3545 - Karma: 792
i never heard of the hot water trick. but i put my poles in a vice grip and yank on it until the grips came off. then leave it in the vice and saw with a hack saw. if you dont have a hack saw just buy the replaceable hack saw blades at a hardware store and put some thick gloves on and cut away. its much cheaper than buying the whole hack saw itself
Dec 31 2010 8:01PM
0 0
All times are Eastern (-5)