ok well i sorta need help with this as soon as possible cause my mountain opens tommorow and i need to get my breaks back on. during the summer i broke my breaks on my summer setup and i took them off. i skied on the skis from then on out until now. my mountain is strick with sking without breaks. i just bought new breaks that are supposed to be compatable with my dynastar px12 bindings and i cant seem to get them on. can you guys show me the order and possibly why i cant get them to fit.
on a side note i know that there are three screws that go into the binding where the break is. does the two outside screws go into the binding before you put the breaks on? because when i try that the center bolt wont reach far enough to grab onto the binding itself.
id like to figure this out before the end of the night so help is greatly appreciated and will be awarded +k.
here is a pic with a few different things id like to know
the circles i drew is a question if they are at the right angle. like are they bend because i feel this is the main problem because they are not fitting so when i try to put in the center screw to the area of the hexagon i drew it falls short and it wont reach the center of it. also the squares are a question about the order of the screws. are these screws supposed to be there before i try to get the breaks in because they wont fit between the holes on the actual break. thank you very much and would like to here from someone who actually takes therew bindings off and on instead of the kids that they think they thoink they know everything.
