Member of the Month

hi_vis360
November, 2024

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

Binding Question

profile picture
Jules.
Posts: 768 - Karma: 9

About to get a pair of lizzys mounted at dead center for a 335. on a px12. is there going to be a problem getting them adjusted at my 322 bsl? and if i have to remount will i be able to at dead center?

Aug 15 2010 11:14PM
0 0
profile picture
Jules.
Posts: 768 - Karma: 9
bump
Aug 15 2010 11:16PM
0 0
profile picture
no_steeze
Posts: 23992 - Karma: 4,273
no and no

unless they were originally mounted while adjusted to the smallest they go then you should be fine, there's plenty of adjustability in a px12. if too small, you will most likely not be able to fit another set of holes in at dead center while keeping the new holes 1cm away from the old ones
Aug 15 2010 11:20PM
0 0
profile picture
Jules.
Posts: 768 - Karma: 9
so where would i get them mounted at? i really dont want to mount them back from center, but if its close i will i guess.
Aug 15 2010 11:21PM
0 0
profile picture
no_steeze
Posts: 23992 - Karma: 4,273
well they will most likely fit, otherwise you have to move them back about 1cm, so -1
Aug 15 2010 11:25PM
0 0
profile picture
Caucasian_Asian
Posts: 2447 - Karma: 1,665
If you mount the PX12s for a 335 dead-center, they should adjust down to fit a 324.

But when you put the 324 in the bindings you will find yourself ~5mm ahead of center.  Better to mount the PX12s for a 324 on center and adjust back to fit the 335.
Aug 15 2010 11:27PM
0 0
profile picture
no_steeze
Posts: 23992 - Karma: 4,273
yep take this into account. since the heel adjusts and not the toe it'll push the boot center forward if you move the heel forward a lot
Aug 15 2010 11:34PM
0 0
All times are Eastern (-5)