Spray paint and skis

should be alright as long as you got the right kind of spray paint. if its meant to stick yo plastic you should be okay, but that is a specific kind, if you just bought generic spray paint it will probably peel and chip off

its whatever i had in my basement haha

yeah it'll probably just chip with use, but at this point you can always just keep re-painting it.

krylos is the best paint to use. just better quality overall, and more durable. expect anything to chip though, maybe even with the ski's flexing. I just finished a pair of cutches and my backpack, and they turned out really well. so much fun making a dank stencil

heres how you do it. if you want, you can probably get those looking about new if you do it right.

Disclaimer: test out the topsheet in an inconspicuous spot. if the graphics are printed on the top (and not behind) the topsheet, youll sand them off)

step 1: sand the topsheet smooth with something around 200 grit or so. its best to use wet dry stuff, cause youll need it afterwards. you can get multipacks typically for like 5 bucks.

once all your chips are sanded down, and its got a nice even faded look to it, its time for

Step 2: paint. any clear paint that doesnt suck will usually do. if you want, used the for plastic stuff. give er a few thin coats, letting dry between them.

Step 3: wetsand. super easy, lots of water, work your way down through the grits, the higher you go the shinier it ll be. after each round of wetsanding, youll see low spots that arent sanded. recoat and repeat until satisfied.