Member of the Month

KilaTsunami
October, 2024

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

Multiple pieces of pvc

profile picture
J-KLEMP
Posts: 337 - Karma: 11
has any body ever used more then just one pvc pipe for there rail? like have 2 seperate pipes inline with each other. is this possible?
Mar 20 2010 6:05PM
0 0
profile picture
funkmaster
Posts: 617 - Karma: 1,876
yep plenty of people do this
Mar 21 2010 12:06PM
0 0
profile picture
_Joe_
Posts: 316 - Karma: 726
very easy to do if you do it right, just take time to line them up perfect, and if you need too just take a chisle or knife or something and just file down the edge
Mar 22 2010 12:34PM
0 0
profile picture
J-KLEMP
Posts: 337 - Karma: 11
ok thanks
Mar 27 2010 5:34PM
0 0
profile picture
I_Am_Mod
Posts: 13214 - Karma: 3,753
cut off the ends under 45°, and line em up...

schematically your box is like this;


--ski direction--> ====/ /==== ---->

do ya understand?
Mar 27 2010 7:53PM
0 0
profile picture
J-KLEMP
Posts: 337 - Karma: 11
i know what you mean but im not sure that will help much at all but i may be wrong (proboly am).  i think it'll be the same as if there just straight up and not cut at the 45 it'll just be at an agle rather then straight up and down would it make a differnce? just tell me if im wrong haha you can be a dick if needed
Mar 28 2010 7:50PM
0 0
profile picture
Kajex
Posts: 1069 - Karma: 178
make the 2nd portion a little bit lower. if its only like a half inch or so it shouldnt affect your slides, and you wont catch the edge at the connection.
Mar 29 2010 5:16PM
0 0
All times are Eastern (-5)