Member of the Month

KilaTsunami
October, 2024

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

Quick help- how to set forward pressure on P12's

profile picture
7ender
Posts: 195 - Karma: 28
Okay, yes I know I should have a certified tech look and these and set them up etcetc but i'd like to learn how to do this myself.  I WILL have these looked at, so please don't tell me to just have a tech do it.

The bindings I have are P12's, not px12's.  At least I think, here's a picture of them http://www.getboards.com/snow/bindings/Look04/P12-LIFTER-QUARTZ_zm.gif

I know on the px12's, there is a yellow gauge, but how do i know on these bindings?  I read that the heel adjustment screw should be flush with something (unclear) when the pressure is correct.  Could someone elaborate on that?  Or tell me the correct way to know?

Thanks
Dec 12 2009 4:57PM
0 0
profile picture
Silence
Posts: 16030 - Karma: 150
yeah, wormscrew at the back should be flush with the back of the housing when the binding is engaged
Dec 12 2009 5:11PM
0 0
profile picture
7ender
Posts: 195 - Karma: 28
Thanks.

How precise should it be?  The housing is sort of angled, while the screw top is flat...when is it considered "flush"?  It's a little hard to explain so I can get a pic if necessary. 
Dec 12 2009 5:14PM
0 0
All times are Eastern (-5)