I was riding down a pretty steep slope of soft snow the other night carrying a fair bit of speed when my left ski hooked on a buried bent over tree tip and sent me flying. After ragdolling for a little while I got up and when I tried to put on my left binding, I found that the entire wing section of the toe piece had twisted a full 90 degrees and gotten stuck there. I had to ski down on one ski to get something I could use to hammer it back into place. Once I got it back into place I was able to click into it no problem, and I rode them down the last run to the lodge and nothing bad happened. My concern is that I have been skiing since I was 5, and have never seen a binding get this far tweaked out. Could this have damaged the binding in some way?
Thanks. oh yeah the bindings are px14's