Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
Full tilt and jester compatibility problems
Posts: 65
-
Karma: 37
So I was thinking about getting jesters but a few people have said they had compatibility problems. I don't really remeber what they were but I have for sure heard people say that full tilt and jesters didn't work well together. Who uses this setup? what's the problem? should I get jesters? I have konflicts by the way.
Posts: 2349
-
Karma: 165
i know someone who has full tilts and jesters, and i havent seen/heard of any problems. idk though, i dont have them myself.
Posts: 1374
-
Karma: 29
Ive got FT classics, and griffons on hellbents. they do the trick, and are the best binders ive ever had
Posts: 9141
-
Karma: 12,883
I have FT booters and I had Griffons with them and they worked perfectly together. If I remember correctly, FT worked with Marker to make the two compatible, so it should they should be perfect together (I might be wrong on them working together though - but they worked fine for me).
Posts: 3807
-
Karma: 191
Posts: 2499
-
Karma: 44
Arnt pretty much all boots and binders compatible?
Posts: 1090
-
Karma: 76
Most of my friends actually all of them ride with griffons and some saught of FullTilt and they haven't had any problems at all.
Posts: 65
-
Karma: 37
Ok, I have definitely heard that people have problems. This was over on tgr though
Posts: 6657
-
Karma: 10,893
Full Tilt and Dalbello 3-piece boots have slightly thinner toe pieces than traditional boots (they are still ISO DIN standard though) and first generation Marker Duke/Jester/Griffon/Baron bindings did not adjust to them and there was a small bit of play in the toe/boot interface. This year's Marker bindings have redesigned toe wings to address this so there shouldn't be any issues. You can also get new toe wings to retro fit older bindings.
All times are Eastern (-5)
