Member of the Month

hi_vis360
November, 2024

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

What to plug old mount holes with?

profile picture
stickstompin
Posts: 564 - Karma: 24
I am remounting my skis myself and wondering what is best material to fill the old mount holes with? +k for help!!!
Nov 9 2009 6:39PM
0 0
profile picture
BWalmer
Posts: 9141 - Karma: 12,885
waterproof epoxy, good luck with the mounting.
Nov 9 2009 6:42PM
0 0
profile picture
skiP.E.I.
Posts: 7840 - Karma: 22,124
At shops they have little plastic plugs that they epoxy in.
Nov 9 2009 7:03PM
0 0
profile picture
.Max.
Posts: 2930 - Karma: 701
Golf tees. lightley hammer it into the hole which was previously filled with wood glue and break it off. then  file down the stub and let it dry for a few hours. cheap and effective
Nov 9 2009 7:15PM
0 0
profile picture
stickstompin
Posts: 564 - Karma: 24
Thanks, what about using silicone (caulk) in the hole and then covering that with waterproof epoxy?
Nov 9 2009 7:19PM
0 0
profile picture
BWalmer
Posts: 9141 - Karma: 12,885
the golf tee idea is better, or you could get a thin wooden dowel to put in there with wood glue then epoxy over that. I don't think silicone would be the best plan.
Nov 9 2009 7:25PM
0 0
profile picture
kickel
Posts: 242 - Karma: 10
well the silicone is not really solid so it'll move plus the holes are small enough that even if you just got a small tube of epoxy you should have more than enough to fill em all, all the way up. so just do all epoxy. 
Nov 9 2009 7:26PM
0 0
profile picture
stickstompin
Posts: 564 - Karma: 24

ok, thanks think i might try the golf tee thing (if i can find one) or just use epoxy.

Nov 9 2009 7:28PM
0 0
profile picture
.Max.
Posts: 2930 - Karma: 701
^  the good thing about golf tees is they fit perfectley in a ski screw sized hole
Nov 9 2009 7:30PM
0 0
profile picture
LBJJ
Posts: 683 - Karma: 1,730
straight epoxy is the same as shoving in somthing just fill the hole with epoxy it works just fine.
Nov 9 2009 9:16PM
0 0
profile picture
DHogg
Posts: 3462 - Karma: 237

many things work, these are the best if you want to do it properly. You can probably get some a shop for close to nothing too.

http://tognar.com/binding_tools_boot_canting_glue_ski_snowboard.html

Item #SPK-SPW/Item #SPK-SPB

Nov 9 2009 9:23PM
0 0
profile picture
headlight
Posts: 165 - Karma: 15
Set white wood gloe or epoxy or silicone seal in the hole. Snip the pointly end off as much as reasonable, softly hammer it down and use a chisel to cut off the excess... use a marker to colour the hole
Nov 9 2009 9:26PM
0 0
All times are Eastern (-5)