Member of the Month

KilaTsunami
October, 2024

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

Getting metal ready to slide

profile picture
steezerampage
Posts: 2171 - Karma: 214
I am making a metal rail and was wondering what to do to make it better for sliding.  Its gonna be about a four inch wide flat rail.  do i sand, then paint, then wax?  Also someone please invite to build a jib.  Thanks
May 29 2009 5:18PM
0 0
profile picture
deleted5
Posts: 14507 - Karma: 13,507
candle wax any wax will do just rub it on
May 29 2009 5:19PM
0 0
profile picture
n8myton
Posts: 395 - Karma: 24
wax is key.
May 29 2009 6:08PM
0 0
profile picture
grapesoda
Posts: 999 - Karma: 31
yea i made this mistake after i built my metal rail. all amped to hit it and as soon as my skis touched the metal, bam they didnt even move and i fell.  i rubbed ski wax on it and sprayed it with water and it was all good after a few hits.
May 29 2009 6:49PM
0 0
profile picture
PeeDuBzz
Posts: 1010 - Karma: 134
i wanna make a metal rail too friend has one mad legit wax works fine....
build a jib invite too plz (:

May 29 2009 7:26PM
0 0
All times are Eastern (-5)