Member of the Month

KilaTsunami
October, 2024

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

FKS Screws

profile picture
summersover
Posts: 5777 - Karma: 233
I have a couple pairs of FKS' that i got from my uncle who runs a race program and theyre in decent shape but the majority of the screws are stripped so its almost impossible to get them out of the old skis much less use them to mount on new skis. Is there anywhere I can find new ones? Special order? Some sort of store?
Feb 20 2009 9:33PM
0 0
profile picture
gnarrr
Posts: 823 - Karma: 12
they use the same screws as any other binding and any ski shop will have them.
Feb 20 2009 9:42PM
0 0
profile picture
strongmark
Posts: 3278 - Karma: 883
go into the back of a shop and do some rummaging.

thats your best bet, you want to make sure you have the right length screws, otherwise youll be in trouble.
Feb 20 2009 9:43PM
0 0
profile picture
summersover
Posts: 5777 - Karma: 233
yeah thats it i have some newer rossi ones that would work but they're way too long
i guess ill have to do some searching maybe check with my uncle
Feb 20 2009 9:44PM
0 0
profile picture
Silence
Posts: 16030 - Karma: 150
Just grind the long screws down?
Feb 20 2009 9:48PM
0 0
profile picture
summersover
Posts: 5777 - Karma: 233
that could work for the toe but the heel ones are weird if i use screws that are the same size but shorter (by like 1/8 inch) will that be too easy to pull out in the heel?
Feb 20 2009 9:53PM
0 0
profile picture
Silence
Posts: 16030 - Karma: 150
Check the ski for the screw dimensions and go with that, you should be fine
Feb 20 2009 10:04PM
0 0
profile picture
strongmark
Posts: 3278 - Karma: 883
naw theyd be the proper size.

if the bindings were coming off race skis, more likely than not, the screws will be the proper length for mounting the bindings with the ~1/8" risers made for fks bindings.

since im assuming that you dont have/dont want to use the risers, those screws that you have would be 1/8" too long because of the lack of riser, and therefore, 1/8' too long for the ski.  use those screws and youll likely deal with dimpling in the base.  ya dont want that.

i would bring them to a shop with experience mounting that binding.  it was made for a reeeeally long time, so they usually will have a whole mess of leftover screws for them.  or, if not, you could grind the screws down, just be sure not to overdo it.
Feb 20 2009 10:05PM
0 0
profile picture
summersover
Posts: 5777 - Karma: 233
thanks a lot man
ill definetely look into this, i wanted to use them as a bit of a teaching tool for mounting on old skis before I strap these monsters on my good skis so ill probably go to a shop once ive had my fun and let the experts work their magic
+k-ed up
Feb 20 2009 10:11PM
0 0
All times are Eastern (-5)