Member of the Month

KilaTsunami
October, 2024

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

PVC Rails

profile picture
EC_skee_ur
Posts: 9 - Karma: 11
does anyone have any good ways to set up or create pvc rails? im trying to figure out the best way so i get it right the first time.
Jan 31 2009 8:58PM
0 0
profile picture
Sholte
Posts: 2929 - Karma: 12
someone get this kid a invite to build a jib 101.
Jan 31 2009 9:07PM
0 0
profile picture
garettnorthey
Posts: 3049 - Karma: 173
Build the frame out of wood. 2x4's are usually the method of choice. Screw on your PVC pipes from underneath the rail upwards into the pvc.
Jan 31 2009 9:23PM
0 0
profile picture
max...
Posts: 1379 - Karma: 802
another way is to put large holes on the top of the pvc with a big drill bit and screw down from the inside of the pipe into your 2x4....but honestly there are a shit load of ways you can make one so just be creative.....
Jan 31 2009 9:57PM
0 0
profile picture
SteevJee
Posts: 1916 - Karma: 144
this is what i did with mine.

Also you can go steal a big huge pvc pipe from construction sites, and you dont need to do anything to it but stick it in the snow.
Jan 31 2009 9:58PM
0 0
profile picture
JEWbacca
Posts: 1391 - Karma: 30
Your gunna want a few searchbars to mount it on
Jan 31 2009 10:22PM
0 0
profile picture
skibum3
Posts: 63 - Karma: 9
Build the frame out of wood. 2x4's are usually the method of choice. Screw on your PVC pipes from underneath the rail upwards into the pvc.

but set the two legs of the frame about 1 foot in on each end of the 2x4x10.

^^this is what i did
Jan 31 2009 10:55PM
0 0
profile picture
theblacktaco
Posts: 1462 - Karma: 82
ok take 3 ...2x6s....and 2 pvc pipes a 1/2 and inch .... then have the the two outside 2x6s on the ground and the middle one about a 1/4 inch up...then screw the 2 pvc pipes to the middle 2 x 6

Jan 31 2009 11:07PM
0 0
All times are Eastern (-5)