Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
How can i measure my Surface LL2's? (Rockered Measuring Questions)
Posts: 1309
-
Karma: 136
hey so i got a pair of 189 rockered ll2's from seanpistol.
as the topsheets are last years, i've been told the "old" and "young" (traditional and core center) marks on them do NOT work with the skis (this years, rockered) that they're pressed to.
so i need to measure them out.
best way to do this? Thanks!
Posts: 13673
-
Karma: 3,087
What's the rocker profile like?
If the rocker in the tip and tail is the same, just measure straight from tip to tail across the top and along the bottom, and your marks should be similar, and then you can make your call from there.
Going along the base is probably the best and most accurate way to figure it out if the rockers are different.
Posts: 9086
-
Karma: 1,349
so, i might not be right but i think the rocker is the same front and rear, so lay the ski on a flat surface and measure from contact point to contact point to get the center then go from there?
Posts: 5536
-
Karma: -1
This is what I would do.
They're actually sick looking, the 3-stage rocker actually has rocker and regular camber underfoot, probably gets nice pop.
But I think they're stiff as all hell.
All times are Eastern (-5)
