Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
Epoxy or filler for chips?
Posts: 1690
-
Karma: 2,827
So i just got like an inch long chip awhile ago. the top sheet over it is still hangin on. do you think i should cut that off and put like some type of filler on there or use and epoxy to glue it back down?
I searchbared and saw how to epoxy but i wanted to see if i should use like a filler?
I know this should have been posted in Gear but i need a quick response.
Thanks +K
Posts: 1637
-
Karma: 108
good question. i'd like to know the same thing
Posts: 1690
-
Karma: 2,827
sorry to bump, but i really need an answer
+karma will be rewarded
Posts: 16253
-
Karma: 538
I'd cut the chip off and fill it wit epoxy. It will seal the core to keep moisture out.
Posts: 3414
-
Karma: 20
I would cut off the dingly doo dad and fill it with epoxy. epoxy fixes everything.
You could also just throw some duct tape over it.
Posts: 1426
-
Karma: 33
Duct tape fixes everything! I used some shitty epoxy from like wal-mart and it held for half a season but now its starting to chip off, so don't go cheap is my only advice haha. or if you do make sure to get a lot.
Posts: 1959
-
Karma: 713
what happens to the core if the chips let water in, i have some damn big ones
Posts: 6712
-
Karma: 6,751
Top sheet chipping won't threaten the integrity of your ski...it's just cosmetic.
All times are Eastern (-5)
