Member of the Month

KilaTsunami
October, 2024

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

When making a pvc pipe rail/box how do i screw the pvc on

profile picture
TYW
Posts: 125 - Karma: 3,096
I am working on making a pvc rail but i do not know how i should screw in the pvc to the wood.
Nov 26 2008 11:41PM
0 0
profile picture
invader7
Posts: 5756 - Karma: 49
screw it up threw the bottom, or drill a hole in the top and just drop the srew down through the hole if that makes sense
Nov 26 2008 11:43PM
0 0
profile picture
snowisawesome
Posts: 447 - Karma: 76
What i did was I took a 4X6 and drilled a hole thru it and then drilled a hole thru one half of the pvc tube. Then i took a bolt and put it thru both and put a washer and nut on the end to keep it in place
Nov 26 2008 11:48PM
0 0
profile picture
TimmyP
Posts: 2086 - Karma: 128
have someone hold the PVC on drill up from the bottom
Nov 26 2008 11:55PM
0 0
profile picture
sol.
Posts: 231 - Karma: 181

drill larger holes on top, drop in screw and drill through into wood.  bevel edges of top holes or sand them.  also....searchbar////build a jib 101 cult broski

Nov 26 2008 11:59PM
0 0
profile picture
DwreckRoy
Posts: 434 - Karma: 2,156
Drill in on the sides. Or better yet, throw away your pvc and get a rail welded for you, pvc gets too cold and shatters really easily. Already broke one this year.
Nov 27 2008 12:29AM
0 0
profile picture
-Kieran-
Posts: 1009 - Karma: 12
when me and my friends made ours we put wooden dowels in the middle of the pvc and then drilled up from the bottom
Nov 27 2008 2:44AM
0 0
profile picture
0123456789
Posts: 9226 - Karma: 148
how i did mine. i cut holes in the sides, and drilled at an angle thru the bottom. check da pic. also screws also go allthe way down, but i just drew it like that to show the screw angles and shitttt


Click for larger image
Nov 27 2008 3:05AM
0 0
All times are Eastern (-4)