Replying to Detuning edges: problem, please help
so my new ar6's edges were pretty sharp so I used a file to detune them (theyre my park ski, and i tend to do a lot of rails). i did an ok job on most of the ski, its not perfect but it works.
the problem is, I went a little to far on one section of the edge (back right) and dulled/rounded it out pretty bad. how much are your edges supposed to be detuned for park? how much is too much?
as of now, im planning on just taking them into the shop and telling the shop to fix them up. however, if theyre detuned much, this could be tough....
advice? thoughts? help? +karma....
thanks
Click to expand post