Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
3rd mounting on hellbents
Posts: 439
-
Karma: 40
okay i am tihnking of getting sth16s to replace the dyNASTY px12jib
because i have pulled the heel piece out of the track, so its not too awesome
they are on their second mount at -1 from true centre i believe and i would like to mount them
again at that point with sth16s. so basically my question is is the hole pattern different enough to get a third mount out of them?
ohh and the first mount was like 4.5 back from true with s810ti (it was not me so dont ask why i had shitty bindings on them)
Posts: 1160
-
Karma: 121
im pretty sure that mounting skis more than once makes them weaker
Posts: 439
-
Karma: 40
yeah usually about 3 is the limit
but the first time was pretty far back im not too concerned with those
i am with the holes at-1 from true
cus i want to mount them there again with another binding
Posts: 1911
-
Karma: 156
well what are your options? 1.)mount them a thrid time, and then ride them and then mabey they'l pull out. 2.) replace the broken part on the dynastars? or3.) not ride them.......?
Posts: 439
-
Karma: 40
i think i have to replace bindings
because i am 6 foot2 and 165
and riding fat skis and there is alot of leverage on the heel piece and what not
so that is why it came out of the track
so if i replace it/get it fixed there is a possiblity of it happening again
so is there any one that knows the different hole patterns between the 2 bindings?
Posts: 439
-
Karma: 40
could heli coiling be an option?
i just want some input
Posts: 16030
-
Karma: 150
I'm pretty sure the STH has the same mount pattern on the heel than the S914 (if i'm wrong and its the same as the S916 then there I think there is a 5th screw)
You could always just mount another cm back..
Posts: 423
-
Karma: 43
YEah if the new holes are gonna be too close to the old ones you can use steel wool and glue to fill the old holes. THen use heli coils and it should hold. THere are a lot of threads on TGR about this.
Posts: 13673
-
Karma: 3,085
I have S914s on my Hellbents, and STH 16s on my Wrenegades.
The STH has five screws, with four being basically the same, but that fifth screw right under the heel. I honestly don't know anyone could rip it out.
All times are Eastern (-5)
