Member of the Month

hi_vis360
November, 2024

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

Px12 lifter question

profile picture
Peter.
Posts: 23796 - Karma: 13,014
say i want to buy the lifter binding, but then take the lifter part off. would it be the same height as the px12 jib then?  the lifters i found are much cheaper.
Sep 9 2008 6:07PM
0 0
profile picture
cobra_commander
Posts: 16909 - Karma: 4,682
technicaly the jib comes with a set of 3mm lifter pads that do nothing whatsoever, so no it would be closer to the ski then the jibs,  Also you would either need to cut the screws down or get new ones since the ones that come with the lifters would be too big if mounted without the lifter. Shops will usualy charge a little extra for this.
Sep 9 2008 6:14PM
0 0
profile picture
Peter.
Posts: 23796 - Karma: 13,014
how difficult is it to get the lifter pads off? 

http://www.porterstahoe.com/istar.asp?a=6&id=C7050!LOOK

http://www.porterstahoe.com/istar.asp?a=6&id=C8050!LOOK

and whats the difference between those two?
Sep 9 2008 6:52PM
0 0
profile picture
MtHoodMeadows
Posts: 106 - Karma: 10
It is not hard at all - the bindings sit on top of the pads and are not really connected by anything except the mounting screws - you just need to make sure to get the proper length mounting hardware.  I have three pairs of skis with Px12 lifters and I had all of them mounted without the lifter pads.
Sep 9 2008 7:07PM
0 0
All times are Eastern (-5)