Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!
When activated, the SpeedGenie system measures the speed at which your vehicle is being driven. When you press the switch, the system remembers your current road speed and uses this as your own personal speed limit. When you drive at a speed 10% higher than this set limit, the system will 'beep' at you to warn you. All the time you are above your set limit, the system will give 3 beeps every 4 seconds. When you drop below the set limit, the system stops beeping. When the system is beeping, it also flashes the light built into the operating switch.
As an example, if you press the switch at 40 mph, the system will alert you when your speed reaches 44 mph and will stay active all the time you are above this speed. When your speed drops below 44 mph again, the system stops beeping.
Each time you press the switch, your current road speed is used as the limit. As you enter different speed limits, you just adjust your road speed accordingly and then press the switch to set your new limit.
How do I operate SpeedGenie?
As with all good products, operation could not be easier! The sequence is as follows:-
Setting the System
Step 1 Drive at the speed you wish to be limited to. Step 2 Press the switch to activate the system. The switch will light to indicate that the system is on. Step 3 If the selected speed is exceeded, the system will beep and the switch light will flash. Step 4 To set a new limit, just press the switch again when you are at your required speed.De-activating the system
Step 1 Press and hold the switch down for 2 seconds. The switch light will go out. Step 2 The SpeedGenie is now de-activated until you require it again.