Member of the Month

KilaTsunami
October, 2024

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

Quick Question

profile picture
TylerS
Posts: 2720 - Karma: 49
I just got a 2' by 4' piece of HDPE from usplastics.com. I got 1/4" thick. Can i just use a regular circular saw to cut it? what type of blade is the best to do it with?
Feb 15 2008 10:59PM
0 0
profile picture
i0z
Posts: 896 - Karma: 40
i have butchers block which is basicly the same thing(im pretty sure) but i just used my circular saw to cut it and it worked fine...just take a piece of sandpaper to the edges when your done so there not as rough from being cut
Feb 16 2008 9:12AM
0 0
profile picture
moonofendor
Posts: 1484 - Karma: 14
how much did it cost?
Feb 19 2008 2:14PM
0 0
profile picture
snowlover6402
Posts: 2 - Karma: 10
Hey man you wanna use a blade with small teeth and a lot of them id use a table saw if possible. with bigger blades your more likley to chip it if it hits at a wrong angle. good luck.
Jun 3 2008 9:53AM
0 0
All times are Eastern (-5)